Большой Воронежский Форум - Показать сообщение отдельно - маленькая скорость коннекта у Acorp M56EMSF-1

Mong · 19.04.2005, 13:01

народ в чем грабли, на других линиях работает на ура (у меня 76 АТС) но и другие модемы у меня номарльно пашут на линии вот статистика может кто что знает:

Unimodem Diagnostics/W32, version 1.1.0.0, compiled at Mar 14 2002 18:01:05
(c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet)
----------------------------------------------------------------------------
Diag Command Specification rev.: 0.0
Call Setup Result code : Data Answering signal detected
Multi-media mode : DSVD, 1.2
DTE-DCE interface mode : Async data
TX/RX signal power level, -dBm : 13/21
Estimated noise level, -dBm : 28
TX/RX Negotiation : V.34/V.34
TX/RX Symbol Rate : 3200/3200
TX/RX Carrier frequency, Hz : 1829/1829
TX data rate (Last/Init) : 28800/28800
RX data rate (Last/Init) : 31200/31200
Temporary carrier loss count : 0
Carrier Rate Re-neg count : 0
Retrains Requested/Granted : 0/1
Protocol/Compression : V.42 LAPM/V.42bis
Error control frame size, bytes: 128
Error control timeouts in TX : 0
Error control NAKs received : 3
TX/RX flow control : V.24 ckt 106/133 / V.24 ckt 106/133
TX/RX chars sent : 39221771/1067671552
TX/RX chars lost (data overrun): 0/0
TX/RX I-Frame count : 1511168/8194560
TX/RX I-Frame error count : 2816/1
Termination Cause : No Previous call

Rockwell Diagnostics/W32, version 1.3.0.0, compiled at Jun 13 2002 22:35:24
(c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet)
----------------------------------------------------------------------------
Connection time : 00:19:01
Handshake Time/Retries : 21 sec/0
TX Rate (Last/Init/Min/Max) : 28800/28800/28800/28800
RX Rate (Last/Init/Min/Max) : 31200/31200/31200/31200
почему больше не коннектит, даже не пытается
Modulation/Protocol/Compression : V.34/LAPM/V.42bis
TX Symbol rate : 3200
TX/RX carrier frequency, Hz : 1829/1829
Signal Level (TX/Power Drop), -dB : 13/3
RX Signal Level (Last/Min/Max), -dB : 20/20/19
Band Edge Lower/Upper, Hz : 150/3825
Round trip delay, ms : 3.188
EQM Value (Last/Min/Max/Negative) : 17/14/20/0
EQM Samples Running Sum : 000E
EQM Last 10 Readings : 19 16 16 16 18 18 17 17 17 18
SNR Ratio (Last/Min/Max), dB : 48/48/48
TX/RX Non-linear Encoding : OFF/OFF
TX/RX Precoding : OFF/OFF
TX/RX Constellation Shaping : OFF/ON
TX Trellis Encoding : 16 state
TX Pre-emphasis : 0
TX/RX state (Max TX/RX, Last TX/RX) : 67H/67H, 67H/65H
Error Correction Status : SABME:T UA:R XID:T,R SYNC
Dual PCM/120 Hz detection : Yes/No
что это значит, до черты?
Energy at 3750Hz/Average Energy : 1230/1286
Retrains (Issued/Granted/Fast) : 0/1/0
Renegs (Issued/Granted) : 0/0
Retrans per frame/Frames rejected : 1/1
Total number of REJ sent/received : 1/11
Last Retrain/Reneg reason : Retrain/rate reneg successful
Last Retrain/Reneg requested : Remote Retrain
Minutes Since Last Retrain/Reneg : 16
Fallback to V34 reason : Data Pump early decision to FB to V34
причину не могу расшифровать может кто знает
Disconnect reason : NONE
Remote Manufacturer/Licensee Code : Conexant/Conexant
Remote Manufacturer's Product Caps : K56Flex, V.90
Remote V.8bis caps (type) : Digital (Server)
Remote V.8bis caps (K56Flex mode) : K56Flex prototype mode not supported
Remote V.8bis caps (K56Flex version): 1.1
Remote K56Flex RAM version supported: 70
Remote Coding used/forced by server : A-law/Yes
Remote controller version number : 0
Remote supports symbol rate (1,2,5) : 2743:ON 2800:ON 3429:ON 3429-TX:ON
Remote supports symbol rate (3,4) : 3000-L:ON 3000-H:ON 3200-L:ON 3200-H:ON
Remote power drop support : ON
Remote max symbol rate difference : 0 steps
Remote is a CME modem : No
Remote supports V.34bis : Yes
Remote frequency source : External
CRe/CRd/CL/MS/ACK/NAK received : Yes/No/Yes/No/Yes/No
V.8bis success/V.8bis neg started : Yes/Yes

Home Edition beta 12a by DDiX.For Russia
TERMINATION REASON.......... NONE
LAST TX rate................ 28800 BPS
HIGHEST TX rate............. 28800 BPS
LAST RX rate.............
HIGHEST RX rate............. 31200 BPS
PROTOCOL.................... LAPM
COMPRESSION................. V42Bis
Line QUALITY................ 017
Rx LEVEL.................... 022
Highest Rx State............ 67
Highest TX State............ 67
EQM Sum..................... 000E
RBS Pattern................. FF
Rate Drop................... FF
Digital Loss................ None
Local Rtrn Count............ 00
Remote Rtrn Count........... 01
Flex fail 9481834246E0
LAST DIALED NUMBER..........

19.04.2005, 13:01	#1
Mong мечтаю о ... Сообщений: 1,331 Регистрация: 01.05.2003 Возраст: 43 Не в сети	маленькая скорость коннекта у Acorp M56EMSF-1 народ в чем грабли, на других линиях работает на ура (у меня 76 АТС) но и другие модемы у меня номарльно пашут на линии вот статистика может кто что знает: Unimodem Diagnostics/W32, version 1.1.0.0, compiled at Mar 14 2002 18:01:05 (c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet) ---------------------------------------------------------------------------- Diag Command Specification rev.: 0.0 Call Setup Result code : Data Answering signal detected Multi-media mode : DSVD, 1.2 DTE-DCE interface mode : Async data TX/RX signal power level, -dBm : 13/21 Estimated noise level, -dBm : 28 TX/RX Negotiation : V.34/V.34 TX/RX Symbol Rate : 3200/3200 TX/RX Carrier frequency, Hz : 1829/1829 TX data rate (Last/Init) : 28800/28800 RX data rate (Last/Init) : 31200/31200 Temporary carrier loss count : 0 Carrier Rate Re-neg count : 0 Retrains Requested/Granted : 0/1 Protocol/Compression : V.42 LAPM/V.42bis Error control frame size, bytes: 128 Error control timeouts in TX : 0 Error control NAKs received : 3 TX/RX flow control : V.24 ckt 106/133 / V.24 ckt 106/133 TX/RX chars sent : 39221771/1067671552 TX/RX chars lost (data overrun): 0/0 TX/RX I-Frame count : 1511168/8194560 TX/RX I-Frame error count : 2816/1 Termination Cause : No Previous call Rockwell Diagnostics/W32, version 1.3.0.0, compiled at Jun 13 2002 22:35:24 (c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet) ---------------------------------------------------------------------------- Connection time : 00:19:01 Handshake Time/Retries : 21 sec/0 TX Rate (Last/Init/Min/Max) : 28800/28800/28800/28800 RX Rate (Last/Init/Min/Max) : 31200/31200/31200/31200 почему больше не коннектит, даже не пытается Modulation/Protocol/Compression : V.34/LAPM/V.42bis TX Symbol rate : 3200 TX/RX carrier frequency, Hz : 1829/1829 Signal Level (TX/Power Drop), -dB : 13/3 RX Signal Level (Last/Min/Max), -dB : 20/20/19 Band Edge Lower/Upper, Hz : 150/3825 Round trip delay, ms : 3.188 EQM Value (Last/Min/Max/Negative) : 17/14/20/0 EQM Samples Running Sum : 000E EQM Last 10 Readings : 19 16 16 16 18 18 17 17 17 18 SNR Ratio (Last/Min/Max), dB : 48/48/48 TX/RX Non-linear Encoding : OFF/OFF TX/RX Precoding : OFF/OFF TX/RX Constellation Shaping : OFF/ON TX Trellis Encoding : 16 state TX Pre-emphasis : 0 TX/RX state (Max TX/RX, Last TX/RX) : 67H/67H, 67H/65H Error Correction Status : SABME:T UA:R XID:T,R SYNC Dual PCM/120 Hz detection : Yes/No что это значит, до черты? Energy at 3750Hz/Average Energy : 1230/1286 Retrains (Issued/Granted/Fast) : 0/1/0 Renegs (Issued/Granted) : 0/0 Retrans per frame/Frames rejected : 1/1 Total number of REJ sent/received : 1/11 Last Retrain/Reneg reason : Retrain/rate reneg successful Last Retrain/Reneg requested : Remote Retrain Minutes Since Last Retrain/Reneg : 16 Fallback to V34 reason : Data Pump early decision to FB to V34 причину не могу расшифровать может кто знает Disconnect reason : NONE Remote Manufacturer/Licensee Code : Conexant/Conexant Remote Manufacturer's Product Caps : K56Flex, V.90 Remote V.8bis caps (type) : Digital (Server) Remote V.8bis caps (K56Flex mode) : K56Flex prototype mode not supported Remote V.8bis caps (K56Flex version): 1.1 Remote K56Flex RAM version supported: 70 Remote Coding used/forced by server : A-law/Yes Remote controller version number : 0 Remote supports symbol rate (1,2,5) : 2743:ON 2800:ON 3429:ON 3429-TX:ON Remote supports symbol rate (3,4) : 3000-L:ON 3000-H:ON 3200-L:ON 3200-H:ON Remote power drop support : ON Remote max symbol rate difference : 0 steps Remote is a CME modem : No Remote supports V.34bis : Yes Remote frequency source : External CRe/CRd/CL/MS/ACK/NAK received : Yes/No/Yes/No/Yes/No V.8bis success/V.8bis neg started : Yes/Yes Home Edition beta 12a by DDiX.For Russia TERMINATION REASON.......... NONE LAST TX rate................ 28800 BPS HIGHEST TX rate............. 28800 BPS LAST RX rate............. HIGHEST RX rate............. 31200 BPS PROTOCOL.................... LAPM COMPRESSION................. V42Bis Line QUALITY................ 017 Rx LEVEL.................... 022 Highest Rx State............ 67 Highest TX State............ 67 EQM Sum..................... 000E RBS Pattern................. FF Rate Drop................... FF Digital Loss................ None Local Rtrn Count............ 00 Remote Rtrn Count........... 01 Flex fail 9481834246E0 LAST DIALED NUMBER..........